GM68D (4WD)
KAMA
| Availability: | |
|---|---|
| Quantity: | |
The KAMA GM68D is a four-wheel-drive diesel tipper offered in two supplier-specified payload configurations: 8 tonnes and 10 tonnes. For distributors and project buyers, the selection starts with the required load, access roads, unloading area and destination requirements. Confirm the chosen configuration in the order specification rather than treating the two versions as interchangeable.
| Specification | 8-tonne configuration | 10-tonne configuration |
|---|---|---|
| Model reference | GM68D (4WD) | GM68D (4WD) |
| Supplier-suggested payload | 8,000 kg | 10,000 kg |
| Gross vehicle weight stated in reference sheet | 12,600 kg | 14,600 kg |
| Reference curb weight | 4,600 kg | 4,600 kg |
| Fuel | Diesel | Diesel |
| Engine | Yuchai YCD4T1L-130 | Yuchai YCD4T1L-130 |
| Displacement | 3,850 cc | 3,850 cc |
| Rated power | 95 kW at 3,000 rpm | 95 kW at 3,000 rpm |
| Wheelbase | 3,400 mm | 3,400 mm |
| Transmission | 5 forward speeds + reverse, manual | 5 forward speeds + reverse, manual |
| Service brake | Air brake | Air brake |
| Electrical system | 24 V | 24 V |
These figures describe the two reference configurations. Supplier-suggested payload is not a statement of the permitted road load in every country. Confirm the final vehicle plate, axle ratings, body specification and destination registration requirements before ordering or operating. The two reference sheets list the same curb weight; obtain the final configuration drawing and weight confirmation for the selected vehicle.
Consider this model for construction-material delivery, rural project supply and other transport tasks requiring a tipping body. Suitability depends on the material density, required load and actual site conditions. Provide photographs or a description of access roads, gradients and unloading areas when discussing a project.
Four-wheel drive is a configuration feature, not a guarantee that a loaded vehicle can travel safely on any slope or surface. Confirm operating limits and unloading procedures from the documentation supplied with the final vehicle. Do not select a truck by body volume alone: a full body of dense material may exceed the permitted load.
Configuration: select the 8-tonne or 10-tonne reference version and request its complete specification.
Body and loading: confirm internal cargo-body dimensions, side height, material, tipping arrangement and the intended goods.
Driveline: confirm the four-wheel-drive system, axle specifications and operating instructions for the ordered version.
Destination: specify the country, steering requirement, registration route and applicable emission requirements.
Support: agree the service documentation, identification-based spare parts list and workshop preparation.
The reference sheets state Euro IV. This does not by itself establish approval for registration in a particular destination. Review the applicable vehicle documents and local requirements before confirming a batch. The available cabin reference image shows left-hand drive; any alternative steering configuration requires separate confirmation.
Send the destination country, intended use, required payload configuration, material carried, usual route, preferred body arrangement and planned order quantity. Include any registration or technical-document requirements. These details allow the vehicle and support scope to be checked against the project.
Contact KAMA about the GM68D four-wheel-drive diesel tipper and request the configuration sheet for the version you intend to order.
Both are offered. Specify which reference version you require so that the final configuration, vehicle weights and supporting documents can be confirmed for that order.
Do not assume this. The reference sheets state different gross vehicle weights. Confirm the complete approved configuration and axle limits; an 8-tonne version should not be treated as authorised for the higher load.
Registration eligibility must be checked for the specific destination and vehicle configuration. A model description or emission label alone is not sufficient confirmation.
No. Photographs illustrate the vehicle appearance. The signed-off configuration and technical documents determine the supplied equipment.
